MTE Hydraulics manufactures a wide variety of hydraulic pumps, motors and power units. MTE Hydraulics pumps, motors and power units can be found on the following typical applications:
Large and small auto hoists, man lifts, elevated work platforms, scissor lifts, dock levelers, conveyors, packaging machines, machine tools, compactors, crimping machines, presses, robotic equipment, tailgate lifts, dump bodies, cab tilts, emergency backup units, bale spikes, snowplows, tow bar hoists, logsplitters, harvesting machinery, lift platforms, scaffolds, presses, waste compactors, car lifts, medical field and dental field lifts, and more.
Hydraulic Pumps |
Two-Stage Pumps |
Hydraulic Motors |
Pump/Motor Units |
| MTE gear pumps are made in three series of models with displacements ranging from 0.5 GPM to 35 GPM. MTE pumps are designed to provide greater torque efficiencies – especially at high speeds and elevated pressures. Numerous shaft, bearing, mounting and seal options are available. Each model is designed to operate as either a single rotation or bi-rotational pump, depending on the application. | Two-stage hi-low pumps are available in our 200 and 300 series. These pumps feature an internal unloading valve that diverts high-volume flow at minimum pressure when high-pressure flow is required. The pumps are designed to direct couple to gas engines or AC electric motors that turn up to 3800 RPM for 200 series, and 3500 rpm for 300 series models. The unloading feature assures that a small, efficient motor can be utilized effectively. MTE two-stage pumps are available in a number of different pump combinations, as well as shaft, flange and porting configurations. | MTE gear motors are made in three series of models with displacements ranging from 0.5 GPM to 35 GPM. The unique gear tooth design and trapping reliefs provide quiet, smooth operation at high speeds and pressures. The high pressure shaft seal will withstand continuous back pressures up to 200 PSI. Anti-friction needle bearings are standard for speeds ranging from 500 RPM to 4,000 RPM. Steel backed, leaded bronze bearings are utilized for higher speed applications. MTE motors are available in single or bi-rotational operation, with built-in check valves. | Pump/motor units are available in both our 100 and 200 series in a number of configurations where a complete self-contained hydraulic system is not required. Displacements available range from 0.1 GPM to 5 GPM. Single or multiple section gear pumps can be close-coupled to standard, heavy duty and permanent magnet 12 and 24 VDC motors, with or without start solenoids. Pumps can be built with integral relief, check and solenoid valves and can accept a variety of porting arrangements and sizes. |
For technical assistance and sales enquiries, contact us:
- Phone: 1-888-WAINBEE (924-6233)
- E-mail: Sales, Technical Services, General Enquiries.